Many people may be intimidated by the thought of working on a bathroom bowl set-up. However, if one has the right equipment and the proper instructions, it is not a hard task. It is important to get it right whether you are replacing an old toilet or installing an entirely new one during the bathroom restoration. A well-connected bathroom bowl guarantees a stable, leak-unfastened suit and clean operation, stopping any future plumbing issues. For a swift and reliable installation procedure, visit https://www.plumbersingapore.org/toilet-bowl-installation/ .
Let’s break down the installation process step by step;
1. Gather your tools
Completing a quicker and more efficient process depends on the right tools available. To make the process smoother, gathering and preparing the tools could assist the person. Among the supplies that are needed would be the polyvinyl chloride screws which will go inside the rubber padding that will support the toilet, a wrench that will tighten the screws, and a level to ensure the toilet’s foundation is even. You can always contact the professionals at https://www.plumbersingapore.org/ if you are unsure about the assistance or tools required in the installation process.
2. Dispose of the Old Toilet
If replacing the old toilet with a new one is imperative, the first step is to remove the bathroom toilet. This can traditionally be accomplished by switching off the water to the toilet and draining the tank using a wrench. Then, immediately unscrew the bolts attached to the floor.
3. Toilet Flange
In those cases, when you are expected to take charge of the installation, the flange has to be inspected and thus follow these steps:
- Look out for harm: If there are any cracks, rust, or put on at the flange, the bathroom won’t be able to feature effectively. In such instances, the flange could need to be replaced to prepare for the reinstallation of the restroom.
- Clean the flange: Remove any wax sticking to the ring and the flange. A ring that does not provide optimal services would be attached to surfaces.
- Check the height: The arm’s mounting location has to be optimally flush with the floor. If it is not low enough, a standard should be maintained, as the toilet may bulge out.
4. Fitting the Wax Ring
After that, position a fresh wax or rubber gasket on the wax ring. A wax ring ensures a watertight seal at the junction of the toilet bowl’s body and the restroom flange. It is usually wise to position the ring so its holes are over the center of the flange.
5. Mounting the Toilet Bowl
Gently pick up the toilet bowl and place it above the wax ring, ensuring that all the bolts on the flange go through the holes on either side of the toilet’s base. Gradually lower the toilet over the ring, making it flat so that evenly distributed pressure can help form the wax ring.
6. Fitting the Toilet
Once the toilet has been positioned, make certain to steady it by tightening the bolts that attach the bathroom to the concrete slab. Subsequently, use a wrench to tighten the bolts correctly, but don’t go overboard.
7. Water Plumbing Reconnection
Follow these simple steps to make the task easier:
- Attach the water line: Install the water supply line to the tank’s inlet valve so that it fits well.
- The bolted connection needs to be tightened. A wrench is required to ensure proper tightening; again, do not do it too much, as it might damage the thread.
- Water can be turned on: Slowly turn the water supply valve to fill the tank while observing the connection for any signs of leakages.
8. The Task of Inspecting for Leakages
Use a level on a toilet that is now in use to confirm that no signs of leakages have been detected around the toilet base, specifically at the junction where the water supply meets the toilet. If so, tighten the bolted connections around the bathroom as required. Some leakage can also be avoided by adding a small piece of plumber’s tape to the water connection.
